Rake On Roof Edge

Size and type of roof rake boards.

Rake on roof edge.

The rake edge should be installed at the rakes above the underlay of the roof. It is typically perpendicular to the eave. The rake of a roof is the outer edge that runs from the eave to the ridge or peak of the roof. Rake boards are installed on the gable ends of brick houses to cover the exposed top edge of the brick.

Mark where the drip edge begins to overhang and one inch further out from that overhang. Cut the entire drip edge by your second mark so that it only hangs past the edge by an inch. Generally speaking there are three main types of roof rakes. Installing the rake edge in this position closes off the edges of the underlayment specifically.

They are referred to as overhanging exposed overhanging and boxed in and abbreviated or sometimes called extended. Size and type of roof rake plates. Product overview gibraltar s galvanized steel gable rake flashing is applied over metal panels along the rake edge to direct rain water away from the fascia. This is done to seal the edges of the roof and to protect the roof s components from wind driven rain.

Then cut out the topmost portion of the drip edge by your first mark. The roof rakes can also be exposed or closed. The rake edge is the edge of these slopes. Though there are many shapes of drip edge available it is important to use a product which does not hinder water from running off the roof.

Preformed drip edge can be made of aluminum galvanized steel or copper. The rake plates are installed at the ends of the brick houses to cover the exposed top edge of the brick. First place your drip edge on the rake edge. Gable rake flashing is a professional trim product that covers the exposed ends of metal roofing panels resulting in a neater appearance.